3D Printing Time Lapse – Colosseum

By chunkyadmin,

  Filed under: 3D Printing
  Tagged with: , , ,
  Comments: None

Time lapse of 3D printed Colosseum. Time lapse taken from my Octoprint server attached to my Printrbot Simple Makers 1405 using the standard Raspberry Pi camera and a wide angle clip on lens.

Original model is by CausalJoemama7 is on Thingiverse by MakerBot and can be found here – http://www.thingiverse.com/thing:962416.

My make can be found here – http://www.thingiverse.com/make:221455

Print Settings Below:
Filament: Printed using 3D Prima 1.75 PLA – White
Filament used: 11.359m 33.0g
Layer Height: 0.2064mm
Temperature: 210°C
Perimeters: 2 at 0.4mm (0.8mm total)
Infill: 25%
Raft: Yes
Support: None
Brim: No
Speed: 20mm/s
Time: About 5 hours



Be the first to write a comment.

Your feedback